英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字，中文词皆可：

安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • Yellow Bullet Forums
    A forum community dedicated to drag racing drivers and enthusiasts Come join the discussion about racing, builds, pro mods, hot rods, events, turbos, nitrous, superchargers, and more!
  • Speed-Tech Diffuser Plate Question | Yellow Bullet Forums
    I have an speedtech diffuser plate I was wanting to spray around 300hp nitrous I was wondering has anyone ever flowed or blueprinted one of these plates I was going to use 98-102 jet on nitrous side On all other plates I have used that gets me around 300hp But speedtech chart shows 92
  • Roll control amps? - Yellow Bullet Forums
    How many amps does a roll control pull? Wiring up my new race car and not sure if I need to run it through a relay or straight off of a momentary switch? Trans brake I don’t believe needs a relay? Thanks in advance!
  • NITROUS and QUENCH | Yellow Bullet Forums
    Hello guys, Im looking for a recommended quench clearance for a 400 cubic inch LS Has a 4 030 bore with 12 2:1 compression 3 9 stroke 68cc Dart LS3 head with NO chamber softening Has a Cam motion Nitrous solid roller 267 287, 756 748, 116 2"-2 1 8" x 4" collector headers Cid intake with a
  • sliding wishbone versus panhard rod | Yellow Bullet Forums
    I am about to start on my newest project, a 3rd gen dragradial car, i plan to minitub it for the 315's, install coilovers behind the axle, which would make using the panhard rod almost impossible, in its place i am thinking of using a sliding wishbone, anybody done this before? are there any
  • Inner tie rods for a wilwood rack? | Yellow Bullet Forums
    I'm looking for one new inner tie rod for a Wilwood rack Anyone know were I could fine one I tried part stores and Wilwood, both say they can't get them
  • Leaning a 1050 Dominator - Yellow Bullet Forums
    Any good tips on leaning out a 1050 Alky Dominator? It's too rich at idle but leaning out the idle mixture screws leaves a bad transition from staged to full throttle
  • nitrous fuel for stand alone tank | Yellow Bullet Forums
    Hi all i have some Questions i am getting closer to finishing up my nitrous plate system I have a small block ford 347 10 5 to 1 stock block I run 93 octane normally I will use a 150 shot I have a dedicated 1 gallon fuel cell for the nitrous with pump and regulator What would be a good
  • Mounting Fuel pressure regulator - Yellow Bullet Forums
    It seems to be a popular concept to NOT mount the fuel pressure regulator rigidly in the engine compartment I have seen several dangling by cable ties or just the fuel lines supporting it I have heard from several top Carb builders that the regulators should be loosely mounted We
  • Piston above the deck | Yellow Bullet Forums
    Ok guys quick question sbf Windsor, pistons are sitting 035 above the deck my plan is to run a 080 Headgasket to compensate for it, I'm certain it will be fine n a the engine will make around 700 n a I'm planning on spraying a 175 through a plate Do y'all think this engine will be ok with





中文字典-英文字典  2005-2009