英文字典中文字典


英文字典中文字典51ZiDian.com



中文字典辞典   英文字典 a   b   c   d   e   f   g   h   i   j   k   l   m   n   o   p   q   r   s   t   u   v   w   x   y   z       







请输入英文单字,中文词皆可:

overawe    
vt. 威慑

威慑

overawe
v 1: subdue, restrain, or overcome by affecting with a feeling
of awe; frighten (as with threats) [synonym: {overawe}, {cow}]

Overawe \O`ver*awe"\, v. t. [imp. & p. p. {Overawed}; p. pr. &
vb. n. {Overawing}.]
To awe exceedingly; to intimidate or subjugate or restrain by
awe or great fear.
[1913 Webster]

The king was present in person to overlook the
magistrates, and overawe these subjects with the terror
of his sword. --Spenser.
[1913 Webster]


请选择你想看的字典辞典:
单词字典翻译
overawe查看 overawe 在百度字典中的解释百度英翻中〔查看〕
overawe查看 overawe 在Google字典中的解释Google英翻中〔查看〕
overawe查看 overawe 在Yahoo字典中的解释Yahoo英翻中〔查看〕





安装中文字典英文字典查询工具!


中文字典英文字典工具:
选择颜色:
输入中英文单字

































































英文字典中文字典相关资料:


  • Charging LiOn battery pack - All About Circuits
    So, you CC CV charger will make sure that it does not charge the battery pack with a higher current than you set Or if you do not want to use a CC CV charger at all, you can indeed use a typical 12,6V power supply but in that case I would just insert a small series resistor to its output to limit its charging current That can be also a nice
  • Pinout for LiON Rechargeable Battery | All About Circuits
    The battery is nominally 18 V The tool uses only 4 pins: A, B, D, and E It does not connect to pin C which has a voltage on it The charger also only uses 4 pins, but it uses pins: B, C, D, and E It does not use A which I measured as the largest voltage Thank you for any information you have on the pinout of these batteries Click to expand
  • NiCd battery charger circuit diagram | All About Circuits
    A more sophisticated charger would monitor the battery voltage and reduce charging current as the battery terminal voltage approaches the manufacturers declared voltage (typically 1 2 - 1 35 volts per cell, to prevent overcharging a fully charged state can be maintained with a trickle charge of no more than the I 100 rate
  • Converting old battery charger to bridge rectifier
    I have a 30• year old battery charger starter I would like to get working The transformer has 8 metal lines coming out of it that plug into a steel plate that the positive charger cable attached to I assume each pair are for the 4 different amperage settings of the charger I assume I could
  • Milwaukee custom charger for work ute | All About Circuits
    The battery "thinks" it is charging, it shows an indicator light on the battery, and even blinks it - but no power goes in to the battery So, I've decided to just get a portable (3rd party) charger from AliExpress, and then use a boost circuit with CC CV (i e current-limited) boost circuit to power it
  • AA Battery Charger using TP4056 - All About Circuits
    Hello, I'm trying to build a AA rechargeable battery charger Targeted battery is duracell 1300mAh-1 2V and the board is TP4056 The board produces 4 12V ~ 4 2V and 1AMP output I need to step down the voltage to 1 2 V Board manufacturer suggested to change Rprog resistor R3 if you want to
  • SLA Backup Battery Charger Recommendation - All About Circuits
    If the battery voltage drops below the trickle-charge voltage, the charger will revert to the charging mode (here shown at the 26s point), until it is again at the charging voltage
  • Schumacher battery maintainer SEM-1562A analyzed
    Some time ago I bought this battery maintainer for use on a small 12V lead-acid battery I found the battery had little charge after some winter months on the maintainer, but seemed fine on a cheap transformer-rectifier charger, and on the machine's own charging circuit I measured the
  • Ryobi 18V lithium battery: charging without original charger
    I was trying to see if I could charge the Ryobi P102 Lithium battery without the original charger (a working battery) According to some videos I have viewed, all one needs to do is attach charging current, 20 or so Volt to the + and - terminals of the battery I let the battery drain to 18V
  • NAPA 85-1010 Battery charger repair - All About Circuits
    I was given a NAPA 85-1010 battery charger that stopped working and I'd like to try and fix it It's 12 volt with settings for 2 amp, 40 amp, 60 amp and 200 amp jump start but both 60 and 200 amp are on the same position on the control switch On the 2 amp setting it's putting out 8 8 volts, on





中文字典-英文字典  2005-2009