Stihl Ignition Module Air Gap. . . - Arborist, Chainsaw Tree Work Forum Here's the problem, the stihl setting gage seems to set the air gap too tight, like 0 004" measured between the ignition module arms and the flywheel magnets using a feeler gage set It seems as though the center coil pick up on the ignition module has a wider air gap Now my question, what is the proper way to measure an ignition module air gap?
AC Delco R45TS gap out of the box - Team Chevelle Just picked up a new set of plugs to go with my freshly installed HEI conversion, from Dave Ray, and they are all gapped at 045 I thought they were set up out of the box for points at 035 Maybe not, but will be at the outer limit for the HEI Just putting this out there for anyone running
Spark Plug Gap - BBC - Team Camaro Tech Things that determine resistance is the plug wire conductor (metal conducts better than carbon impregnated fiberglass strands), the spark gap, and the resistance in the plug (the R in the designation of an AC-delco plug denotes an internal air gap to prevent power from bleeding off too soon)
026 Ring gap. Too much? - Team Chevelle Building a 454 030 overbore and pre gapped rings are 25 26 thou gap That is a bit more than I would like Mild street build Naturally aspirated ok, or do I have to buy file fit that cost a fortune? Will this gap give too much blow-by?
Spark Plug gap on a 454 with Edelbrock 35830 EFI, 1971. . . Hello All, Just looking to see what I should gap spark plugs to with a 454 using an Edelbrock 35830 EFI kit? I read 0 32-0 45, I'm leaning towards the high side Thoughts? Thanks, Tom
Pertronix III And Spark Plug Gap Revisited! - Team Chevelle A year ago I asked this question about plug gap and the Pertronix III with the Flamethrower HC 60000v coil Pertronix contradicted themselves a year ago one time saying 005 over stock gap and another time saying 007 over stock gap, I know 002 wont make or break anything but still two
Which plugs to use and at what gap - Team Chevelle It is no secret that we have many different types of ignition systems HEI GM type, Crane, MSD, Pertronix etc So what plug, heat range, gap and plug material should we use? Platinum or copper? Which will work best for a given ignition system and engine Today' ignition systems for the modern
Spark Plug Gap on 454 - Team Chevelle Can anyone tell me what the spark plug gap on a 454 should be I changed the plugs on my 454 and it seems as if it is missing a little at low RPM Does anyone recommed a good spark plug manufacturer as well It is a mildly built motor Thanks in advance Drew